Willow Remote: Initial Setup with your TV

BRAND SEARCH

On the remote control perform the following:

If at any time during the setup process a mistake is made the process can be halted and the remote reverted to normal function by pressing and holding the Text/SHIFT button and pressing Stop at the same time.

  1. Determine the manufacturer of your TV set.
  2. Look up the 4-digit code under the manufacturer of your TV and make note of it.
  3. Turn on your TV.
  4. Press and hold the 1 and the 3 buttons at the same time for 3 seconds. The TV standby button should remain lit.
  5. Enter the 4-digit code from the manufacturer.
  6. Point the remote at the TV set, press and hold the TV Standby Button or Mute.
  7. When the TV turns off or mutes release the button. This may take some time.
  8. Press and hold the Text/SHIFT button then press Stop to finish the setup.

The following buttons on the Willow Remote should now work on your TV:

  • TV Standby
  • AV Source Select
  • Volume Up
  • Volume Down
  • Mute

If any of the above buttons do not work with your TV, perform a Key Fix, described at the bottom of the page.

AUTO SEARCH

On the remote control perform the following:

This process can take a long time, occasionally up to 5 minutes.

  1. Turn on your TV.
  2. Press and hold the 1 and the 3 buttons at the same time for 3 seconds. The TV standby button should remain lit.
  3. Point the remote at the TV set, press and hold the TV Standby Button or Mute.
  4. When the TV turns off or mutes release the button. Again, this may take up to 5 minutes.
  5. Press and hold the Text/SHIFT button then press Stop to finish the setup.

The following buttons on the Willow Remote should now work on your TV:

  • TV Standby
  • AV Source Select
  • Volume Up
  • Volume Down
  • Mute

If any of the above buttons do not work with your TV, perform a Key Fix, described below:

KEY FIX

  1. Press and hold the 1 and 9 buttons simultaneously for about 3 seconds until the TV Standby button is lit.
  2. Try all the above mentioned buttons.
  3. If the TV does not respond to a button, then hold that button down. The remote control will now step through alternative settings. When the TV responds correctly release that button.
  4. Repeat with the other buttons if necessary.
  5. One finished, press the Text/SHIFT and Stop buttons at the same time.