Big Button Remote Programming Guide

image

PROGRAMMING THE BIG BUTTON REMOTE CONTROL: QUICK SET-UP

Quick Number Brand
0
Pace DTA
Sanyo
1 SA/CISCO, Samsung, Pace DigitalSony
2 Motorola DigitalSamsung
3 Motorola DTALG
4 Evolution DTAToshiba
5 CISCO IPTVPanasonic
6 ADB IPTVPhilips
7 TechnicolorHitachi
8 Amino 140/540 IPTVSharp
9 Motorola IPTVVizio
  1. Turn on the component you wish to program. I.e. to program your TV, turn on your TV.
  2. Press and hold the Device key, TV or CBL, for 5 seconds until the Device LED will blink once and stays on. Continue to hold the Device key press the number key assigned to your brand in the Quick Set-up Code Table and release both the Device key and the number key to save the code. The Device LED will blink twice to confirm that the code is stored.
  3. Point the remote control at the component.
  4. Press the power button. If it turns off, it is programmed for your component. If it does not turn off, use the Manual programming or Auto Search Programming method described below.

PROGRAMMING THE BIG BUTTON REMOTE CONTROL: MANUAL PROGRAMMING

  1. Turn on the component you wish to program. I.e. to program your TV, turn on your TV.
  2. Press the Device button, TV or CBL, and the OK/SEL button simultaneously for 3 seconds. The corresponding device LED will turn on indicating that it is ready to be programmed. The LEN will remain on for 30 seconds. The next step must be performed while the LED is on.
  3. Point the remote control toward the equipment and enter the three-digit code number to your brand from the code tables. If there are more than one three-digit number listed for your brand, try one code at a time until your equipment turns off.
  4. Store the three-digit code by pressing the same Device button once again. The Device LED will blink twice to confirm that the code has been stored.

PROGRAMMING THE BIG BUTTON REMOTE CONTROL: AUTO SEARCH

  1. Turn on the component you wish to program. I.e. to program your TV, turn on your TV.
  2. Press the Device button, TV or CBL, and the OK/SEL button simultaneously for 3 seconds. The corresponding device LED will turn on indicating that it is ready to be programmed. The LEN will remain on for 30 seconds. The next step must be performed while the LED is on.
  3. Press the Channel Up or the Channel Down button one at a time or keep it pressed. The remote will emit a series of POWER ON/OFF code signals. Stop pressing, or release, the button as soon as the equipment turns off.
  4. Store the three-digit code by pressing the same Device button once again. The Device LED will blink twice to confirm that the code has been stored.

PLEASE NOTE:

The Big Button Remote can not control the DVR. In order to control your DVR you will need to use one of ValuNet FIBER’s other remote controls.

image

Latest ValuNet Headlines